usb optical mouse driver code 28 windows 7

If the software does not detect any devices, it may point to faulty hardware.If the Logitech mouse still doesn’t register with the PC, you’ll need to check the software settings.The dongle should slip into the port without a lot of resistance, and if you inserted it correctly, the entire metal part should not be visible from the USB slot. Remove the dongle and push it into the slot as far as is possible, while not applying undue force. It is also possible that you didn’t properly insert the dongle into the USB slot.

By using a different USB port, the device may start working again. Some USB ports may stop recognizing devices over time (depending on how other devices configured the port).

If the PC still doesn’t recognize the mouse, you can try a different USB slot.

Move the mouse on the mousepad to see if the computer recognizes the device. Switch on the mouse before reinserting the dongle into the PC’s USB port. Wait a few moments before replacing the battery.

Perform a reset on the mouse by removing the battery (as described in the previous section).

During extended periods of use, the PC may no longer recognize the USB dongle. The Logitech M185 comes with a wireless dongle that fits into one of the PC’s USB slots. This also counts as a hard-reset for the mouse, so if the wireless receiver was the cause of the problem, it could start working after removing and replacing the battery.

Then close the compartment and switch the mouse back on to see if it registers with the PC.

Remove the current battery and replace with one you know has power.

If the PC doesn’t detect any movement, try replacing the battery.

As these models of mice do not come with an LED power indicator, you’ll need to test the power by moving it and looking for the cursor on the PC’s screen. Move the mouse after placing it on the mouse pad to see if the PC recognizes the device.

Usb optical mouse driver code 28 windows 7